Uniden FP105 - Manual (Page 7)

4. Plug the AC Adaptor into a standard 230-240VAC wall outlet and switch it.
Plug the AC Adaptor lead into the power socket at the back of the phone.
Use only the AC adaptor supplied with this phone.
Place the power cord and line cord so that they do not create a trip hazard or
where they could become chaffed and create fire or electrical hazard.
The telephone will beep and the display will show SET TIME I DATE
Assuming you subscribe to a Caller ID service, the time and date will be automatically updated
when the first call is received.
After 10 seconds the display will show TOTAL CALLS 00
!
If you do not subscribe to a Caller ID service, or you wish to set the TIME/ DATE
.
manually p/ease refer to the Advance User Options Menu on page 27.
BACK UP BATTERY
on the screen means;
l The back up battery is either low or not fitted.
In case of power failure or accidental unplugging of the AC Adaptor, a 9V backup battery
(supplied) will save the telephone’s memory.
If required, you can mount your phone directly on the wall.
Before mounting your phone, please consider the following:
l Select a location away from electrical cables, pipes or other items behind the mounting
location that could cause a hazard when inserting screws into the wall.
l Make sure the wall material is capable of supporting the weight of the telephone.
l
Use the screws (supplied) with anchoring devices suitable for the wall material where the
telephone will be placed.
1. Insert two mounting screws 100mm apart. Allow
about 5mm between the wall and screw heads for
mounting the phone.
2. Gently pull out the handset retainer
tab, turn 180˚ and re-fit.
3. Install battery.
4. Plug in the line cord and AC Adaptor
jacks to rear side of the FP105.
5. Attach the wall mounting bracket to the
bottom of the telephone as shown.
6. Place the base unit on the screws and push down until it’s firmly seated.
7. Plug the other end of the telephone line cord to the wall and AC Adpator to the AC outlet.