Uniden FP102 - Manual (Page 23)

USING YOUR FP102
USING
YOUR
FP102
USING THE PRE-PROGRAMMED FEATURE BUTTONS
(Australian Model Only)
Instant access to some of Telstra’s most popular network service features have
been factory programmed into this telephone for your convenience.
Block CID
Each time you make a call, your telephone number is automatically forwarded to
the party you are calling (unless your number is a silent number). In certain
cases you may wish to prevent your number being sent.
Pick up the handset or press the button. Wait for the dial tone, press
the button and then dial the telephone number of the person you
wish to call. Your telephone number will be withheld for this call only.
Divert On
Telstra’s ‘Call Forward No Answer’ Service is available for diverting calls to
another number if your phone is not answered within 20 seconds (approximately
7 or 8 rings).
Pick up the handset or press the button. Wait for the dial tone, press
the button and then hang up. The telephone will automatically dial
the access code ‘*61#’ and will enable ‘Call Forward No Answer’ to the fixed num-
ber you have previously assigned the divert to.
Pick up the handset or press the button. Wait for the dial tone then
press . You will hear a long beep and a
voice announcement confirming that this feature has been activated, then you can
hang up.
To confirm the diverted number, turn ‘Call Waiting’ off, then dial your own
number. The number you are forwarding your calls to will begin to ring.
The normal Local, Mobile or National Call charges will apply.
NOTE: To program, or re-program the fixed ‘Call Forward No Answer’ number, follow the
example below, replacing the number 9876 5432 with the number you wish to
divert calls to.
23
FP102-OM.qxd 7/12/98 09:28 Page 23