Uniden DECT1725 - Manual (Page 28)

Dial mode
Tone Dialling Switch-Over (Australia only)
Registering a new handset
You can set your phone to use either Tone or
Pulse dialling. The pre-set setting is TONE
dialling, where you will hear a tone beep each
time you dial a number.
Most modern exchanges and switchboards use
Tone dialling, so you should not need to change
this setting. Only change it if your switchboard
uses Pulse dialling or if you cannot make a call
using Tone dialling.
1 Press
to access the main menu.
2 Press or until is
displayed and press .
3 Press or to select and
press .
4 Press or to display either or
PULSE and press .
If you have set your phone to use Pulse dialing, you
can switch temporarily to Tone dialing for the
duration of a call:
1 Press
.
2 Press and hold . Any digits entered after this
long press of will be dialed using tone
dialing.
Registering a new handset
When you register a new handset to your base,
you will be asked to enter the base PIN code.
The pre-set PIN code is 0000. If you wish you can
change this code, see page 29.
Each handset can only be registered to one base
at a time. Before registering, make sure the new
handset is fully charged and that you have the
base and handset in front of you.
1 Press to access the main menu.
2 Press or to select
and press .
3 Press or to select your base number.
4 Press and hold until you hear the
registration tone. You are now in 'subscription
mode'.
If the base already has the maximum number of
handsets (5) registered to it you will hear the
reject tone and you will need to de-register one of
the existing handsets before you can register the
new handset.
See section below for de-registering handsets.
BS SETTINGS
DIAL MODE
TONE
REGISTRATION
On the handset you want to register:
On your base:
[27]
menu/ok
menu/ok
menu/ok
cid
cid
cid
menu/ok
menu/ok
cid
cid
menu/ok
find handset
end
* tone
* tone