Uniden DECT1725 - Manual (Page 13)

Using your phone
Make a call
Adjust the earpiece/receiver volume during a
call
Preparatory dialling (pre-dial)
Handset range
Call timer
1. Press . The symbol is displayed.
When you hear the dial tone, dial the number
you want. The number is shown in the display.
After a short delay the call timer will start timing
the call.
1 In standby mode, enter the number to be dialed.
The number is displayed.
You can enter numbers up to 32 digits long.
Press to delete any incorrect digits.
Press and hold to delete all digits.
2 Press to dial the displayed number.
Up to 300 metres outdoors and up to 50 metres
indoors (in ideal conditions).
If the handset is too far away from the base, during
standby, appears and the symbol will
flash. During a call you will hear a warning tone.
You will need to mover closer to the base for
clearer reception and to avoid being disconnected.
When you make or receive a call, a short while after
the line is connected the call timer will show the
duration of the call in the display in hours, minutes
and seconds. 1 Press or to adjust the volume.
There are five levels.
Searching
[12]
end
end
cid
clear
clear