Uniden DCT7488 - Manual (Page 44)

[ 4 3 ] P H O N E B O O K w w w . u n i d e n . c o m
5) Press select/ /audio tone (or the OK soft key) to
store the name;
Stor e/E dit No . appears.
6) Use the number keypad, * /tone/ , or #/ to enter
the phone number (up to 20 digits). To insert a 2-second pause in the dialing
sequence, press pause/redial.
If you make an error, use menu/clear (or the DELETE soft key on the base) to
erase the incorrect digits. When you are finished, press select/
/audio tone (or
the OK soft key) to store the number.
7) Dist inc tiv e Ri ng appears. Press /volume up/down
to move the pointer to one of the Distinctive Ring
options and then press select/
/audio tone (or the
OK soft key).
If you choose not to store a Distinctive Ring, simply select the "No Selectn"
option.
8) Spee d D ial appears. Press /volume up/down to
move the pointer to select the Speed dial location (10
locations: SPD1-SPD0).
If you choose not to store the name/number as a
Speed Dial, simply choose the "No Selectn" option.
5 V Q T G ' F K V 0 Q
㨫
& K U V K P E V K X G 4 K P I
0 Q 5 G N G E V P
( N K E M G T
5 R G G F & K C N
0 Q 5 G N G E V P
5 2 & ' O R V [
•Selecting a phonebook
location where a
number is already
stored overwrites the
old number. The new
number will be stored
in the phonebook
location.
•When the memory is
full, you will hear a
beep and
Memory Full
appears. You cannot
store names and
numbers.
•The pause key counts
as one digit. Pressing
pause/redial more
than once increases the
length of the pause
between numbers. Each
pause represents a 2
second delay.
note
P
H
ONE
BOOK