Uniden XSA1255 - Manual (Page 25)

4) Enter a name according to the instructions below, then press the select/remote key (XSA1255)or
the select/channel key(XSA1255+1). If no name is required, go to step 5.
• The name can be up to 13 characters.
• Use the #/ and /tone/ keys to move the cursor to the desired location.
• Use the delete/channel key (XSA1255) or the delete/transfer key(XSA1255+1) to delete
characters as needed.
• Press and hold the delete/channel key (XSS1255) or the delete/transfer key(XSA1255+1) to
delete all the characters.
Refer to the letters on the number keys to select the desired characters.
With each press of a numeric key, the displayed character appears in the following order: upper case
letters first, lower case letters next and finally the number corresponding to the key. If you make a
mistake while entering a name Use the /tone/ or #/ key to move the cursor to the incorrect
character. Press the delete/channel key (XSA1255) or the delete/transfer key(XSA1255+1) to erase
the wrong character. Then enter the correct character. To delete all characters, press and hold the
delete/channel key(XSA1255) or the delete/transfer key(XSA1255+1) .
For example, to enter Movies.
1) Press 6. Then press the #/
key to move the cursor to the right.
2) Press 6 six times.
3) Press 8 six times.
4) Press 4 six times.
5) Press 3 five times.
6) Press 7 eight times.
! If the next
character uses the
same number key,
you must press
the #/ key to
move the cursor
over. Otherwise
the next time you
press the number
key, it changes the
character that was
previously set.
[24]
U
S
IN
G
T
H
E
S
P
E
E
D
D
IA
L
M
E
M
O
R
Y