Uniden XSA660 - Manual (Page 33)

27
Remote Operation
You can operate your XSA660 or XSA650 you’re away from home by calling from any
touch-tone phone. When using this feature, remember these important guidelines.
• You should change your Personal Identification Number (PIN) before using
your phone. When you first apply power, the code is set to 80.
• You cannot change the Time and Day Stamp or your PIN code from a touch-
tone phone.
Setting Your PIN Code
Using the phone, you can set a personal two digit code (00 to 99) for your PIN
code. You must use your PIN code to access your Answering System from a touch-
tone telephone.
1. Press and hold
pin . The [0 0 ] display on the Base.
2. Press skip or repeat to select the
first digit of four pin numbers.
3. Press pin again.
4. Press skip or repeat to select the next digit of your pin
number.
5. Press pin again.
You will hear a long tone which indicates that the new code is saved.
Using a Touch-Tone Phone
You can operate your Answering System using
any touch-tone phone. Use this function to
check for recorded messages, play or delete
messages, or even record a new outgoing
message.
1. Call your telephone number.
2. During the outgoing message playback,
press # followed by your PIN number.
3. The Answering System announces the Time
and Day Stamp. The number of messages
stored in memory follows.
4. Use this chart to select the function you
want.
Note: You must enter a command within 2 seconds or the Answering System hangs
up and returns to Standby.
5. When you’ve finished, hang up to exit the system.
Your Answering System automatically returns to Standby.
▼ ▼
▼ ▼
▼ ▼
▼ ▼
pin clock
repeat ogm memo skip
answer page
▼ ▼
▼ ▼
Function Press
Repeat #1
Play Message #2
Skip #3
Delete Message #4
Stop #5
Answer ON #6
Memo Rec/Memo Rec Stop #7
Ogm Rec/ogm Rec Stop
#8
Answer OFF #9
Room Monitor #,*
Remember to press # before
each command number.