Uniden XSA660 - Manual (Page 24)

18
Chain Dialling
After dialling a number you may be requested to enter a special access code, for
example, when performing a banking transaction.
1. Store the access code into one of the memory locations (0-9).
2. Dial the main number.
3. Press
mem and the memory location where you stored the access code at the
appropriate time.
Erasing a Stored Number
1. Remove the handset from the base.
2. Press
mem twice.
3. Press the memory location number (0-9) you want to clear. You hear a long
beep confirming that you have erased the number.
Replacing a Stored Number
Remember your XSA660 or XSA650 phone has 10 memory locations per handset,
represented by the numbers 0-9 on the keypad. If you store a phone number in
one of these locations, then store a different number in the same location later,
the new number will replace the previous one.
If you attempt to dial a
memory location that does
not have a stored number,
the handset will beep rapidly
(error tone) and the phone
will not dial.