Uniden ANA 9610 - Manual (Page 45)

Troubleshooting
If your ANA 9610 Cordless Telephone is not performing to your
expectations, please try these simple steps. If you are still unable to
resolve the problems, contact your PBX Administrator.
Note: Do not attempt to service this unit yourself. All service must be
done by qualified service personnel.
Problem Suggestion
Charge light won’t come
on when Handset is
placed in Charging Unit.
• Make sure the AC Adapter is plugged into
the Base Unit and wall outlet.
• Make sure Handset is properly seated in
Charging Unit.
• Make sure the Sealed Lead-Acid Battery
Pack is properly placed on the Handset.
• Make sure that the charging contacts on
the Handset and Charging Unit are clean.
Conversation
interrupted frequently.
• Make sure that the Base Unit antenna is
fully vertical.
• Move closer to the Base Unit.
• Check for LOW BAT warning.
Warning tone and NO
SERVICE message.
• Move closer to the Base Unit.
Handset doesn’t ring.
• Sealed Lead-Acid Battery may be weak.
Charge the Battery Pack for 5-6 hours.
• Make sure the Base Unit antenna is fully
vertical.
• The Handset may be too far away from
the Base Unit.
• Ensure the Ringer ON/OFF switch is in
the ON Position.
39
P:\ana9610e\9610usae.vp
Mon Aug 30 10:27:04 1999
Color profile: Disabled
Composite Default screen