Uniden UH044DP - Manual (Page 16)

UNIDEN Model UH044DP DELUXE PACK UHF CB Radio
SCANNING
The UH044 has two types of scanning; Open Scanning (OS)
and Group Scanning (GS), OS Scan searches all the channels
and frequencies in its memory continuously. GS Scan has the
ability of monitoring a priority channel every 1.5 seconds while
searching channels and frequencies in its memory.
Scanning allows you to search for active
channels programmed in the OS or GS
memory.
1. Assuming the unit is on CH01 when
switched on.
2. Press and scanning starts.
Scan icon flashes during scanning.
(the absence of GS icon indicates
that the unit is on OS mode)
Allows continuous scanning of channels stored in the Open
Scan (OS) memory.
If an active channel is found, scanning will stop on that channel.
Example. CH40 becomes active
To initiate scanning,
OPEN SCAN (OS) Mode
The factory has preprogrammed all the 40 UHF
channels into the Open Scan channel memory.
However, you can change or customise the channels
by following the steps on programming Scan Channels
on page 17.
If the received signal cease, the unit will
wait for at least 3 seconds for the signal to
return, otherwise scanning resumes.
To skip the active channel, press
momentarily. Scanning
resumes.
To deactivate SCAN, press the or .
OPERATION
15