Uniden DECT2035+2 - Manual (Page 60)

60
Troubleshooting
Installing a telephone line fi lter or DSL fi lter
Any broadband Internet service that uses your telephone
line might interfere with standard phones. The most common
type of these services, DSL, often causes static on your
telephone. Fortunately, an easy-to-install fi lter removes this
static from the line. Technicians who install DSL service
usually leave several fi lters for the customers; if you can’t
fi nd them, call your DSL provider or look in any electronics
store.
Just plug the DSL fi lter into the telephone wall jack and then
plug your phone’s base into the fi lter. Make a test call to
make sure the noise is gone.
Resetting the Handset
You may need to reset your handset in the following instances:
You lose a handset and purchase a new one.
You get the message Registration Failed when you try to register the handset.
You are unable to register any handsets to the base.
When you register new handsets to the base, the handset IDs do not match. (For example, the handset registers
as “Handset #4” but you only have two handsets.)
When you are instructed to by one of Uniden’s call center representatives.
Select the base you want to de-register the handset from (see Selecting the base on page 15).
Press and hold END and # for more than fi ve seconds. Select Deregister HS.
Select the handset which you are operating, and then press MENU/SELECT.
The phone will ask you to confi rm the deregistration. Select Yes. The selected handset will clear its registration
information only from the base it is currently connected to, and then delete the link to the base from its own
memory.
•
•
•
•
•
1.
2.
3.
4.
Telephone
cord
Telephone
wall jack
DSL filter
Telephone
cord
Telephone
wall jack
DSL filter
DECT 2035+1 OM.indb 60 DECT 2035+1 OM.indb 60 15/7/08 12:00:46 PM 15/7/08 12:00:46 PM