Uniden DECT2035+2 - Manual (Page 13)

13
Installing the Phone
Expanding Your Phone
Adding accessory handsets
Your phone supports a total of six cordless handsets, including any that were supplied with your phone. You can now
place a fully-featured cordless handset anywhere AC power is available to connect the charging cradle.
Your phone is compatible with the following Uniden DECT accessory handsets: DECT2015, DECT2035 and
DECT2005. (Please visit our website at www.uniden.com.au for Australian models or www.uniden.co.nz for New
Zealand models for the most up-to-date list of compatible handsets.)
For instructions on connecting the charging cradle, see page 8.
If you purchase any accessory handsets separately, you must register the handsets to the base before you can
use them. (Accessory handsets that come packaged with a base are already registered to that base.)
Registering accessory handsets
When charged, registered handsets display a handset ID number. Handsets that have not been registered display:
↔
To register a DECT2005 accessory handset:
Charge the handset for 15-20 hours.
Place the handset in the base cradle for about thirty seconds. Handset Registering will appear in the LCD.
When the handset has registered to the base, the LCD will display Registration complete then show the handset
ID number.
On the handset, press and hold # until the handset beeps and displays Handset Registering.
When the handset has registered to the base, the LCD will display Registration complete then show the handset
ID number.
If the display shows Registration failed, repeat the process again.
Note: If a handset has ever been registered to a base, reset the handset before you register it to a new base (see
•
•
•
•
1)
2)
3)
4)
5)
DECT 2035+1 OM.indb 13 DECT 2035+1 OM.indb 13 15/7/08 11:59:59 AM 15/7/08 11:59:59 AM