Uniden D1660 - Manual (Page 17)

English - 17
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equip-
ment does cause harmful interference to
radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or more
of the following measures:
xReorient or relocate the receiving
antenna.
xIncrease the separation between the
equipment and receiver.
xConnect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
xConsult the dealer or an experienced
radio/TV technician for help.
FCC RF Exposure Information
This product complies with FCC radia-
tion exposure limits under the following
conditions:
xThe base must be placed to allow a
minimum of 20 cm (8 inches) between the
antenna and all persons during normal
operation.
xThe base must not be collocated or
operated in conjunction with any other
antenna or transmitter.
xThe handset is designed for body-worn
operation and meets FCC RF exposure
guidelines when used with any belt clip,
carrying case, or other accessory supplied
with this product. (All necessary acces-
sories are included in the package; any
additional or optional accessories are not
required for compliance with the guide-
lines.) Third party accessories (unless
approved by the manufacturer) should be
avoided as these might not comply with
FCC RF exposure guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: This equipment meets the
applicable Industry Canada Terminal
Equipment Technical Specifications. This
is confirmed by the registration number.
The abbreviation IC before the registra-
tion number signifies that registration
was performed based on a Declaration
of Conformity indicating that Industry
Canada technical specifications were met.
It does not imply that Industry Canada
approved the equipment.
NOTICE: The Ringer Equivalence Num-
ber (REN) for this terminal equipment is
marked on the equipment itself. The REN
assigned to each terminal equipment
provides an indication of the maximum
number of terminals allowed to be
connected to a telephone interface. The
termination on an interface may consist
of any combination of devices subject
only to the requirement that the sum of
the Ringer Equivalence Numbers of all
the devices does not exceed 5.
Radio equipment
The term IC before the radio certifica-
tion number only signifies that Industry
Canada technical specifications were
met. Operation is subject to the following
two conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device. "Privacy of com-
munications may not be ensured when
using this telephone".
1-Year Limited Warranty
Evidence of original purchase is
required for warranty service.
WARRANTOR: UNIDEN AMERICA
CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden
warrants, for one year, to the original
retail owner, this Uniden Product to
be free from defects in materials and