Uniden MHS050-2 - Manual (Page 15)

E-15 Uniden MHS050-2 Owner’s Manual
NOTE
When you press BOOST and the transmit power is low
( LO - 1W), the radio transmits at maximum high power (HI -
2.5W) except for channels 75 and 76.
5. When you have finished speaking, release PTT or BOOST to
listen for a response. TX then disappears.
One-touch Channel 16/9
Triple Watch
Triple Watch mode monitors channels 16 and 9 for a signal while
you listen to the currently-selected channel. The marine radio
checks channel 16 and 9 for activity every 2 seconds.
1. Press and hold TRI to activate Triple Watch.
2. Press and hold TRI again to exit Triple Watch.
NOTE
While in Triple Watch mode, you can change the currently-
selected channel using CH or CH .
sCanning
The radio can scan the channels programmed into memory (see
page 16). To initiate scanning:
1. Select channel 17.
2. Press SCAN and scanning starts. SCAN
displays during scanning.
The radio will scan memory channels in
ascending order.
If Triple Watch is turned on during the scan, the radio will scan
the memory channels in ascending order. Check channel 9 and
channel 16 every 2 seconds, and then resume scanning the
memory channels.
While monitor-
ing CH 20, press
16/9 to monitor
CH 16.
Press 16/9
again to
monitor CH 9. Press 16/9 again
to monitor the
original channel
(CH 20).
LO LO LO
LO
SCAN MEM