Uniden BC370CRS - Manual (Page 30)

30
Using the Scanner Memories
Once you fill out the above chart, follow these steps to enter or change a
frequency in a memory:
1. Press E/PGM to enter the program mode (the scanner turns on the
PGM icon).
2. If the current channel is not the one you want to program, enter the
memory number then press HOLD.
3. Enter the frequency including the decimal point, then press E/PGM.
4. To program the next memory, press
▲ or ▼ and repeat step 3.
To program a different memory, repeat from step 2.
5. To exit program mode, press HOLD or SCAN or change the scanner’s
mode.
Notes:
• Any frequency you program replaces the previous memory contents.
• If you enter a frequency you have already stored in a different
memory in Step 3, the scanner beeps and displays the channel
where you have previously stored the frequency. If you want to store
the frequency anyway, press E/PGM a second time in Step 3.
• To clear the contents of a memory, enter “0” in Step 3.
• Channels you program are automatically unlocked (see “Locking/
Unlocking Memories) and have Delay turned on (See “Setting
Channel Delay”).
Selecting a Memory
To select a single memory to monitor, press HOLD. The scanner turns on
the
HOLD icon. Then, select a memory by pressing
▲ or ▼ to go to the
memory or input the memory number then press HOLD.
Bank 26 Bank 27 Bank 28 Bank 29 Bank 30
251 261 271 281 291
252 262 272 282 292
253 263 273 283 293
254 264 274 284 294
255 265 275 285 295
256 266 276 286 296
257 267 277 287 297
258 268 278 288 298
259 269 279 289 299
260 270 280 290 300
UB338ZH(BC370CRS) 2/23/06 9:25 AM Page 30