Uniden BC370CRS User Manual
Page 15
11 ./CLR — This key has three functions:
• press to input a decimal point when you enter a frequency.
• press to cancel a number button input - 0 to 9.
• press to clear an error display.
12 “Soft” Buttons — Functions for these 5 buttons depend on the
current mode. The Soft-button area at the bottom of the LCD will show
the buttons’ current function.
13 MODE Switch — Use to select the desired mode: AM/FM; Weather;
Scanner. (Slide switch must be set to Clock)
14
▼
— Press and release to move down through channel numbers in
the following HOLD modes: SCAN, PROGRAM, SERVICE SEARCH,
and WX or the step frequency in LIMIT SEARCH, and AM/FM mode.
(Refer to the frequency and step table on page 10.)
Press and hold for more than 1 second to have the changes run
continuously.
15
▲
— Press and release to move up through channel numbers in the
following HOLD modes: SCAN, PROGRAM, SERVICE SEARCH, and
WX or the step frequency in LIMIT SEARCH, and AM/FM mode.
(Refer to the frequency and step table on page 10.)
Press and hold for more than 1 second to have the changes run
continuously.
16 Headphone Jack — Lets you use an headphone for private listening.
17 External Alert Terminal — Connect a switch-closure activated device
such as a strobe or siren controller to provide additional alerting
options for the All-Hazards alert.
18 AM Loop Antenna — Connect the supplied loop antenna and position
it for best AM Broadcast radio reception.
19 Antenna Connector — Connect an external antenna using a BNC
connector.
15
Introduction
UB338ZH(BC370CRS) 2/23/06 9:25 AM Page 15