USRobotics ADSL 4-Port Router - Manual (Page 11)

9
Status LEDs
The router has several LEDs on its front. The LED conditions listed below indicate the
operational status of the router.
Solid The router is powered on.
Off The router is powered off.
Solid The router is connected to the Internet.
Flashing The router is exchanging data with the Internet.
Off
There is no active Internet connection or the device is
in ADSL bridge mode. For information on bridge mode,
see the User Guide on the installation CD-ROM.
Solid An ADSL link is established.
Flashing The router is attempting to create an ADSL link.
Off There is no current ADSL connection.
(1-4)
Solid
There is a physical connection between the router and
the computer through the corresponding Ethernet port
(note the port numbers above the LEDs).
Flashing
The router and computer are exchanging data through
an Ethernet port.
Off
There is no physical connection between the router
and the computer through the Ethernet port.
Solid
A printer is connected to the router’s USB port. See
the User Guide on the USRobotics installation CD-ROM
for information on using a printer with the router.
NOTE: Do not connect any device other than a self-
powered printer to the USB port. The USB connector
can only be loaded a maximum of 0.11A. Overloaded
operation is hazardous.
Flashing The router and printer are exchanging data.
Off There is no printer connected to the router’s USB port.