Universal Remote Control (URS) AVEX R6 - Manual (Page 16)

Finding a Component’s
Set-up Code Number
If you used the Auto--Search or Learning Methods to
program a component, you may not know the code
number you programmed. Here is a way for you to
identify what that code number is, so you can make
a note in the back of this Manual for future reference.
STEP 1: Press the component button you would
like to verify and the SELECT [SEL] button at the
same time for 2 seconds until the selected component
LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
Page 16
COMPONENT
BUTTONS
SELECT
STEP 2: Press the INFO button and count the
number of times the Component LED light blinks.
This number indicates the first digit of the code.
Next it will pause for about one second and begin
blinking again to indicate the number of the second
digit. Then once again it will pause, then blink,
o indicate the number of the third digit.
Example: One blink, pause, eight blinks, pause,
three blinks indicates code number 183.
Note that ten (10) blinks represent the number 0.
INFO
AV-EXpertManual.qxd 7/12/07 6:41 PM Page 16