Universal Remote Control (URS) AVEX R6 - Manual (Page 10)

Three-Digit Code Set-Up Method
STEP 1: Find the 3-digit code numbers assigned
to your brand from the lists in the back of this manual.
The codes are listed by component category (i.e.,
TV, VCR, DVD, etc.), then by brand name. For
instance, if you would like to locate a code for a
Sony television, first locate the TV category and
then look for the Sony brand.
STEP 2: Once you have located the 3-digit codes
for each of the components that you wish to operate
with your AVEX R6, write them ALL down on a
piece of paper. It’s important that you write down
all the codes listed for your brand because only
one code is going to work with your component.
STEP 3: Manually or using your old remote, turn
on the component you want to program—for exam-
ple, to program your TV turn on your TV set.
STEP 4: On the AVEX R6, press the Component
button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button
at the same time. Hold down both buttons for 2
seconds until the TV Component LED light turns on.
This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds,
the component LED light will turn off. The remote
will exit the programming mode and you will
have to start over.
Page 10
COMPONENT
BUTTONS
SELECT
BUTTON
AV-EXpertManual.qxd 7/12/07 6:41 PM Page 10