beautypg.com

Universal Remote Control (URS) AVEX R6 User Manual

Page 12

background image

Auto-Search Method

The Auto-Search Method is a way you can scan
through all of the codes in the table to find the right
code for your component.

STEP 1:

Manually or using your old remote, turn

on the component you want to program—for example,
to program your TV, turn on your TV set.

STEP 2:

On the AVEX R6, press the Component

button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button at
the same time. Hold down both buttons for 2 seconds
until the TV Component button light turns on. This
signals that you are in programming mode.

IMPORTANT:

You have 30 seconds to perform

the next step while you are in programming mode.
If you do not press a button within 30 seconds,
the component LED light will turn off. The remote
will exit the programming mode and you will have
to start over.

Page 12

UP

ARROW

DOWN

ARROW

STEP 3:

Point the AVEX R6 remote control toward

the component and press the UP arrow (or
DOWN arrow) button once. Each time the UP or
DOWN arrow button is pressed, the code will count
up (or down) one code number and send a Power
OFF signal. When the correct code is sent out, the
component will turn off.

AV-EXpertManual.qxd 7/12/07 6:41 PM Page 12