Uniden DECT2180 Series - Manual (Page 28)

Registering a handset
Does the handset fit in the base cradle?
Yes No
Place the handset
in the base. The
display should
say Handset
Registering.
Disconnect the base AC adapter.
Press and hold FIND HANDSET/INTErCOM while you
reconnect the adapter.
On the handset, press and hold # until the display says
Handset Registering (about 2 seconds).
1.
2.
3.
In about 30 seconds, the display should say Registration Complete.
Pick up the handset & press TaLk/fLasH : you should hear a dial tone.
If... Try...
you don't hear a dial tone
the display says Registration Failed
-
-
Making sure the handset is fully
charged, then trying again.
To register a handset to a different base, see the section
"Expanding Your phone" in the user's guide for the other base.
Handling Liquid Damage
Moisture and liquid can damage your cordless phone.
If the handset or base is exposed to moisture or liquid, but only the
exterior housing is affected, wipe off the liquid, and use as normal.
If moisture or liquid has entered the plastic housing (i.e. liquid can
be heard in the phone or liquid has entered the handset battery
compartment or vent openings on the base), follow these steps:
Handset Base
Remove the battery cover & disconnect the
battery.
Let dry for at least 3 days with the battery
disconnected and the cover off for ventilation.
After the handset dries, reconnect the battery
pack and replace the cover. Recharge the
battery fully (15-20 hours) before using.
1.
2.
3.
Disconnect the AC
adapter to cut off the
power.
Disconnect the
telephone cord.
Let dry for at least 3 days
before reconnecting.
1.
2.
3.
IMporTaNT: You must unplug the telephone line while
recharging the battery pack to avoid charge interruption.
CAUTION! DO NOT use a microwave oven to speed up the
drying process. This will cause permanent damage to the
handset, base and the microwave oven.

