Uniden DECT2180 Series - Manual (Page 14)

Press TaLk/fLasH or spEakEr to dial the number. (You can also
press TaLk/fLasH or spEakEr before you open the CID list. Find the
number you want to dial, then press MENU/sELECT .)
Caller ID menu options
Open the CID list with the phone in standby. Find the number you
want and press MENU/sELECT . Choose one of these CID menu options:
Delete Entry Erase this Caller ID number.
Store Into Pb Add the number to the phonebook. The handset prompts
you to edit the name & number and select a personal ring.
Delete All
Erase this handset's CID list. (This does not affect the CID
lists saved on any other handsets.)
Add Call Block Add the number to the call block list (see page 14).
Using Call Waiting
If you get a Call Waiting call, the phone sounds a tone and displays
any CID information received for the waiting call. Press fLasH ( TaLk/
fLasH on a handset) to switch between the current call and the waiting
call; remember, each time you switch, there is a short pause before
you're connected to the other caller.
Using Seven-Digit Dialing
If you can make a local call by dialing only seven digits instead of ten,
you can tell the phone to hide your local area code in the CID list.
do not enter an area code if your phone company requires ten-
digit dialing. You might not be able to dial from the CId list.
From any handset, open the menu with the phone in standby.
Select Global Setup, then select Area Code.
Use the number keypad (
0 - 9 ) to enter your three-digit area code.
Press MENU/sELECT when you’re finished.
The phone uses the programmed code as a filter. When calls
come in, the phone compares the area code to the programmed
one. If they match, the phone hides the area code in the CID list.
While reviewing the list, press # to toggle the area code off & on.
3)
1)
2)
3)
4)

