beautypg.com

3 input/output connector description – Texas Instruments TPS65023B User Manual

Page 3

background image

www.ti.com

Input/Output Connector Description

3

Input/Output Connector Description

This section describes the jumpers and connectors on the EVM, as well as how to properly connect, set
up, and use the TPS65023B/TPS650231EVM-664.

J1 – VIN

Input voltage from external power supply, recommended maximum 5.5 V. Input current depends
on load but typically is less than 2 A.

J2 – GND

This is the return connection for VIN.

J3 – VINLDO/GND

Input voltage and return for LDO1 and LDO2. Resistor R20 connects this pin to VIN. If an
external power supply is used, remove R20. Recommended maximum input voltage is 5.5 V.

J4 – VSYSIN/GND

Input voltage and return for VSYSIN, one of the input voltages for RTC. Resistor R21 can be
used to connect this input to VIN. If an external power supply is used, remove R21.
Recommended maximum input voltage is 4 V.

J5 – VBACKUP/GND

Input voltage and return for VBACKUP, one of the input voltages for RTC. There are no onboard
connections to a voltage input. Recommended maximum input voltage is 4 V.

J6 – VRTC/GND

Output voltage from RTC circuit.

J7 – Fault Outputs

Four fault outputs are available on this connector:

PWRFAIL – Fault occurs when input voltage is less than 3 V. Pulled up to VRTC when safe; low
for fail.

INT – Fault occurs when a fail is on an input or output voltage; acts as a sum fail. Pulled up to
VIN when safe; low for fail.

RESPWRON – Low reset signal is controlled by SW1, 144 ms. Pulled up to VIN normally.

LOWBAT – Fault occurs when input voltage is less than 3.6 V. Pulled up to VIN when safe; low
for fail.

J8 – I2C

This header duplicates the I2C signals from the J20 interface connector. I2C data (SDA) and
clock (SCL) can be accessed on this header

J9 – VDCDC1

Output from DCDC1 switching regulator maximum output current 1.7 A; default voltage setting is
3.3 V.

J10 – GND

Return for VDCDC1.

J11 – VDCDC2

Output from DCDC2 switching regulator; maximum output current 1.2 A.

J12 – GND

Return for VDCDC2

J13 – VLDO1

Output from low-dropout regulator VLDO1; maximum output current 200 mA.

J14 – GND

Return for VLDO1

J15 – VLDO2

Output from low-dropout regulator VLDO2; maximum output current 200 mA.

J16 – GND

Return for VLDO2.

3

SLVU394 – October 2010

TPS65023B/TPS650231EVM

Submit Documentation Feedback

Copyright © 2010, Texas Instruments Incorporated

This manual is related to the following products: