Teac CR-H500NT - Manual (Page 49)

ENGLISH
49
The clock setting of this unit is automatically adjusted
according to the CLOCK TIME data of an RDS
broadcasting.
If you adjust the clock manually, follow the following
steps.
1 Press the TIME SET button.
Each time the TIME SET button is pressed, the mode is
changed as follows.
Current Time
On Time
Off Time
Source select
< For Europe, the unit uses the 24-hour “military” clock.
For North America, the unit uses the 12-hour clock.
< When no action is taken for 1 minute, the time adjust
mode will be cancelled.
< Press the stop button (H) to cancel the time setting.
2 Press the scroll buttons ( Á/ ) to set the current
hour.
Setting the Clock
3 Press the ENTER button.
The “minute” value blinks.
4 Press the scroll buttons ( Á/ ) to set the current
minute.
5 Press the ENTER button.
The clock starts from 00 seconds.
< The clock setting will not be saved when the AC
power cord is pulled out.
EN_CR-H500NT_T_C.indb 49 EN_CR-H500NT_T_C.indb 49 09.10.6 5:31:45 PM 09.10.6 5:31:45 PM