Toshiba MK6017MAP - Manual (Page 62)

360014937
Copyright ©2000 Toshiba corporation. All rights reserved.
- 562 -
If an error occurs during multi-sector transfer, it will terminate the transfer by setting error information in
status register and error register, without shifting into data transfer mode from the host. CY, HD, SN ( LBA)
registers show the address where error has occurred.
10.8.7 Write Long
7
(32h/33h)
If Long bit is “1”, this command write the data and the associated ECC data information supplied by the host.
The data field transfer is 16 bit wide, but the ECC information is accepted in only 8 bits.
10.8.8 Read Verify (40h)
COMMAND CODE 0 1 0 0 0 0 0 0 REGISTER
REGISTER SETTING NORMAL COMPLETION
DR drive no. no change
CY starting cylinder last possible
HD starting head last possible
SN starting sector start sector
SC no. of sector to be read 00H
LBA starting address last address
This command is identical to a Read command except that DRQ bit is not set and no data is sent to the host.
This allows the system to verify the integrity of the drive. A single interrupt is generated upon completion of
a command or when an error occurs.
10.8.9 Write Verify
8
(3Ch)
COMMAND CODE 0 0 1 1 1 1 0 0 REGISTER
REGISTER SETTING NORMAL COMPLETION
DR drive no. no change
CY starting cylinder last possible
HD starting head last possible
SN starting sector start sector
SC no. of sector to be written 00H
LBA starting address last address
This command is identical to a Write sector command except that verification is not performed. A Write
verify command transfers the number of sectors (1-256) defined in SC register from the host to the drive,
then the data is written on the media. The starting sector is defined in CY, HD, SN (LBA) registers.
Upon receipt of the command, the drive sets DRQ until one sector of data is transferred from the host, then
resets DRQ, sets BSY. In case of multi- sector transfer, it sets DRQ, resets BSY and generate an interrupt to
report the host that the host is ready to receive 1 sector of data. The drive will seek to the target track if the
R/W head is not on the target track (implied seek). Reaching the target sector, the command transfers the
7 ATA/ATAPI-4 defines this command as Vendor specific. The drive supports this command to maintain ATA-3, and the previous
models compatibility. User is recommended not to use this command.
8 ATA/ATAPI-4 defines this command as Vendor specific. The drive supports this command to maintain ATA-3 compatibility. User is
recommended not to use this command.