Toshiba D-VR4XSU - Manual (Page 22)

22
Introduction
Auto clock setting / Setting the video channel
NOTES:
• When shipped from factory, the
video channel is set to CH 3.
• If the unit does not operate prop-
erly, or there is no key operation
from the unit and/or the remote
control: Static electricity, etc., may
affect the operation. Disconnect
the AC power cord once, then con-
nect it again.
Auto clock setting
Preparation:
You must connect the antenna or cable before connecting the AC cord
to the power source.
After the antenna or cable is connected, wait for at least 3 minutes with
the power turned off for the auto clock feature to activate.
After the clock is set automatically, you may have to set the Standard
Time (time zone) and Daylight Saving Time. (See page 25 and 26.)
Press ON/STANDBY to turn on the DVD/VCR after the auto clock op-
eration completed.
• When shipped from factory, the “CLOCK” setting is set to “Auto” posi-
tion.
• If you turn the DVD/VCR on during auto clock setting, the clock is not
set.
• Depending on the reception condition, auto clock setting may take
approx. 30 minutes.
• After a power failure or disconnection of the power plug, the clock will
be lost. In this case, wait 3 minutes before turning the DVD/VCR on.
• With cable box connection, if the auto clock setting is unsuccessful,
select the PBS channel carrying the XDS information, then turn the
DVD/VCR off. After 3 minutes, turn the DVD/VCR on.
• If the clock is not set automatically, set the clock manually. (See page
26.)
Setting the video channel
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR’s channel selector, the TV must be
set to channel 3 or 4 (video channel).
When a TV is connected with the 75 ohm coaxial cable only:
1
Press and hold 3 or 4 on the remote control for 3 seconds in the
standby mode to select CH 3 or 4. The selected channel number
will flash on the display for about 4 seconds.
2
Turn ON the TV and set to CH 3 or 4 to correspond with the chan-
nel selected in step 1.
3
Press ON/STANDBY to turn on the DVD/VCR.
4
Press TV/VIDEO to select the VIDEO position.
The TV indicator will disappear in the display.
5
Select any channel to receive a TV station in your area.
The channel number will appear on the screen for about 4 sec-
onds.
For a push-button TV tuner
If CH 3 or 4 corresponding to the video channel cannot be tuned on
your TV, proceed as follows: set the VCR 3/4 channel selector and the
TV to CH 3 or 4, playback a prerecorded tape and tune the TV to re-
ceive a sharp color picture from the video cassette recorder. Refer to
your TV owner’s manual for details.
2H5-01 P22-30 7/25/05, 23:19 22