Toshiba D-VR4XSU - Manual (Page 17)

Introduction
17
NOTE: If a UHF or VHF antenna is used,
set the TV/CABLE menu option
to the “TV” mode.
TV with single 75 ohm UHF/VHF antenna
input
NOTE: If a UHF or VHF antenna is used,
set the TV/CABLE menu option
to the “TV” mode.
TV with 300 ohm UHF and 75 ohm VHF
antenna inputs
NOTE: If a UHF or VHF antenna is used,
set the TV/CABLE menu option to
the “TV” mode.
TV with 300 ohm UHF and 300 ohm VHF
antenna inputs
DVD/VCR TO TV CONNECTION
After you have connected the antenna to the DVD/VCR, you must connect the DVD/VCR to the TV.
Below are 3 common methods of connecting your DVD/VCR to a TV. Find the type of TV you are using and follow
the connection diagram.
This DVD/VCR has a single 75 ohm output for connection to a TV. If your TV has separate UHF and VHF antenna
inputs (numbers 2 and 3 below), use a splitter to connect the DVD/VCR to the TV for UHF and VHF reception.
Antenna connections
UHF
VHF
TV
75 ohm coaxial cable
(supplied)
Splitter
75 ohm input
75/300 ohm outputs
(not supplied)
UHF
VHF
TV
75 ohm coaxial cable
(supplied)
Splitter
75 ohm input
300 ohm outputs
(not supplied)
UHF/VHF IN
TV
75 ohm coaxial cable (supplied)
The unauthorized recording, use, distribution, or revision of television programs, videotapes, DVDs and other
materials, is prohibited under the Copyright Laws of the United States and other countries, and may subject
you to civil and/or criminal liability.
2H5-01 P12-21 7/25/05, 23:18 17