Toshiba 26A3000A - Manual (Page 12)

12
Getting started
Watching TV programs
Selecting the menu language
Choose from 9 different languages (English, Chinese (CS),
Malay, Thai, Vietnamese, Russian, Arabic, Persian or French)
for the on-screen display.
1
Press
M, then press I or i to display SET UP menu.
2
Press u or U to select Language.
3
Press I or i to select the desired language.
Changing the program position
1
Enter the desired program position number using the
Number buttons on the remote control.
For program positions below 10, use 0 and the required
number e.g., for program position 1.
2
You can also change the program position by using > or
<.
The program position will be displayed on the screen with
the Mono/Stereo/Dual audio status.
Note:
The program position selection change between different
format channels takes several seconds.
Switching between two program positions
You can switch two program positions without entering actual
position number each time.
1
Select the first program position you want to view.
2
Select the second program position with the Number
buttons (0-9).
3
Press
:. The previous channel will be displayed.
Each time you press
:, the TV will switch back and forth
between the two program positions.
Displaying the on-screen information
1
Press
K to display the following on-screen
information.
The information will disappear in 6 seconds.
• Program position or external input mode selected
• Program skip on/off information
• Label (if set)
• Mono/Stereo/Dual audio status
2
To erase the display instantly, press
K again.
Programming channels into the
TV’s channel memory
• First, use the Auto tuning function to preset all the active
channels in your area automatically. Then, arrange the
preset channels with the Manual tuning function so that you
can tune into only desired channels.
• Use the Manual tuning operation if desired channels cannot
be preset with the Auto tuning or if you would like to preset
channels to specific position numbers one by one.
Programming channels automatically
1
From the SET UP menu, press u or U to select Auto
tuning.
2
Press
Q to display the Auto tuning menu.
3
Press
Q to start the automatic search.
The search will begin for all available stations.
The slide bar will move along the line as the search
progresses.
If you make a mistake, simply repeat steps 1-3 to start
again from the beginning.
4
When the automatic search is completed, the TV will
automatically return to the first program position.
5
Press > or < to view the programmed position.
Note:
When you preset the program channel which sound of
broadcast transmission system adopts “M” system, the sound
system may not be tuned correctly if the radio waves transmit
badly. At that time, preset the channel by Manual tuning.
The countries such as Myanmar, Brazil, Chile, Colombia apply
to this case. See page 26 for more details.
AV connection
Manual tuning OK
OK
Auto tuning OK
Language
SET UP
English
OK Picture position
MENU Back Watch TV EXIT
r R
ABCD 4 Stereo
MENU Back Watch TV EXIT
Auto tuning
EXIT for no change.
Press OK key to start. !
Searching
Stop
Pos :2
Auto tuning
EXIT