Tyan Computer TOLEDO S5520 - Manual (Page 56)

56
3.4.6 IPMI
This section allows you to configure the IPMI settings. (This submenu will appear
when an IPMI card is installed.)
PhoenixBIOS Setup Utility
Main Advanced Security Power Boot Exit
IPMI
Item Specific Help
X
System Event Log
X System Event Log (list mode)
X
Realtime Sensor Data
IPMI Specification Version
BMC Firmware Version
System Event Logging
Clear System Event Log
Existing Event Log number
Remaining Event Log number
Event Log Control
SYS Firmware Progress
BIOS POST Errors
BIOS POST Watchdog
OS boot Watchdog
Timer for loading OS (SEC)
Time out action
2.0
0.00.00000000
[Enabled]
[Disabled]
7
(unknown)
[Disabled]
[Enabled]
[Disabled]
[Disabled]
[10]
[No action]
Display the System
Event Log
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
Esc Exit ← → Select Menu Enter Select X Sub-Menu F10 Save and Exit
IPMI Specification Version / BMC Firmware Version
It displays the version of the IPMI Specification and BMC Firmware. (Read only)
System Event Logging
Select [Enabled] to allow logging of system events.
Options: Enabled / Disabled
Clear System Event Log
When set to [Enabled], system event log will be cleared.
Options: Disabled / Enabled
Existing Event Log number / Remaining Event Log number
It displays the number of existing event logs and remaining event logs. (Read only)
SYS Firmware Progress
It records the continual development of BIOS POST.
Options: Disabled / Enabled
BIOS POST Errors
Enabled -> BIOS will halt & display error message if there is any POST error .
Disabled -> BIOS will not halt if there is any POST error.
Options: Disabled / Enabled