TC electronic SDN BHD x32 - Manual (Page 19)

SETUP EXAMPLES
17
Setting up Digital Konnekt x32
AES/SPDIF/TOS in
•
SPDIF is selected for channel pairs 1/2 and 3/4.
• AES is selected for channel pairs 5/6 and 7/8 (no
LEDs are lit).
ADAT in
•
We select Normal Sample rate and route ADAT
channels to ADAT out.
Firewire
•
In the Firewire section we choose to monitor
channels 9/10.
Therefore you must route the main output channels from
your DAW to outputs 9/10.
3-4 1-2 5-6 7-8
adat mon firewire in aes+spdif+tos
1-8
9-16
LOCK
SIG
1/2
3/4
5/6
7/8
1-2
3-4
5-6
7-8
adat
1-8
3-4 1-2 5-6 7-8
adat adat in aes+spdif+tos
NS
DS
LOCK
SIG
1/2
3/4
5/6
7/8 SRC
adat
1-8
3-4 1-2 5-6 7-8
aes/spdif/tos in aes+spdif+tos
SRC SPDIF TOS
FRONT
aes/spdif clock master LOCK
SIG
1/2
3/4
5/6
7/8
Clock
•
In the DAW you select External - as clock source.
This allows you to use the Digital Konnekt x32 as
master clock.
• Make sure that all external devices are set to lock to
external clock
• The “non- TC Electronic” product is set to lock to
external clock. - If this is not possible - use the
sample rate c*onverter on Digital konnekt x32 for
channel 3/4.
* If your external FX has a fixed sample, you have to
run your project using that sample rate.
Now the Digital Konnekt x32 operates as a digital
patchbay as well as an excellent master clock.
setup/util master clock
44.1k
clock rate
aes
/spdif
monitor LEDs
dual wire XLR
hold to select input
security
lock device
adat
WCK in
firewire
INT
48k
x2
x4
SEL
input signal
HOLD TO UN-LOCK
192kHz fs
AES pro out
P