Tripp Lite Omni VS UPS Systems OMNIVS1000 - Manual (Page 2)

Audible alarm and 4 front panel LEDs offer complete UPS and line power status information
1000VA/500 watt power handling ability supports a variety of sensitive electronic equipment
3.5 minutes full load runtime (1000VA/500 watts), 14 minutes half load runtime (500VA/250 watts)
Supports battery replacement via built-in access panel
Short circuit protection in AC and battery mode
$200,000 connected equipment insurance (USA and Canada Only)
Specifications
OUTPUT
Output Volt Amp Capacity
(VA) 1000
Output Watt Capacity
(watts) 500
Nominal Output Voltage(s)
Supported 115V; 120V
Frequency compatibility 60 Hz
Output voltage regulation
(Battery mode) 115V (+/- 5%)
Built-in UPS output
receptacles 8 5-15R outlet(s)
Surge suppression only
outlets 6 UPS outlets, 2 surge-only outlets
Output AC waveform (AC
mode) Sine wave
Output AC waveform
(battery mode) PWM sine wave
INPUT
Rated input current (at
maximum load) 12A
Nominal Input Voltage(s)
Supported 120V AC
UPS input connection type 5-15P
UPS Input cord length (ft.) 6
UPS Input cord length (m) 1.8
Recommended Electrical
Service 15A 120V
BATTERY
Full load runtime (minutes) 3.5 min. (500w)
Half load runtime (minutes) 14 min. (250w)
DC system voltage (VDC) 12
Battery recharge rate
(included batteries) Less than 4.5 hours from 10% to 90%
Replacement battery
cartridge (internal UPS
battery replacement) RBC51
Battery Access Battery access door