Titan Tool 2000XD - Manual (Page 18)

18
TROUBLE SHOOTING GUIDE
SYMPTOM CAUSE SOLUTION
Detector chatters • Using detector • Use detector
or beeps erratically indoors outdoors only
• Using detector near • Move away
power lines from power lines
• Using 2 detectors in • Keep 2 detectors
close proximity at least 20’ apart
• Highly oxidized • Only dig up
buried object repeatable
signals
• Environmental • Reduce sensitivity
electromagnetic until erratic
interference signals cease
Constant low tone • Discharged batteries • Replace batteries
or constant repeating • Wrong type of • Use only 9V alkaline
tones batteries batteries, or fully
c h a rged rechargeable
LCD does not lock • Multiple targets • Move coil slowly
on to one target ID present at different angles
or detector emits • Highly oxidized
multiple tones target
• Sensitivity set • Reduce sensitivity
too high
No power, no • Dead batteries • Replace batteries
sounds • Poor battery • Push batteries in
contact tighter
• Cord not connected •Insert paper spacers
securely (see page 5)
• Check connections
TROUBLESHOOTING
Titan2000MANUAL.qx6 4/22/08 12:29 PM Page 18