Titan Tool 2000XD - Manual (Page 11)

BASIC OPERATION (continued)
ITD
The ITD control is a convenient way to eliminate a known undesirable
metal object from detection.
To demonstrate the ITD control:
1) Set the detector in All-Metal Mode
Note: ITD functions in all modes, but is best demonstrated
first from the All-Metal Mode.
2) Pass the search coil over an undesirable object.
3) Notice the Target Indication
Note: You can only ITD objects that register under the
five left-most segments (from Iron to Zinc).
4) Press ITD. An "R" appears under the segment to be eliminated.
5) Pass the search coil over the same object again.
The undesirable object is eliminated from detection
The ITD control is easy to use in the field. As you are detecting, and
encounter an object which you wish to eliminate from detection, simply
press the ITD touch pad after detecting the object.
The ITD control eliminates the most-recently detected object category
from detection. The category eliminated is indicated with an "R".
HEADPHONE JACK
Using headphones (not
supplied) with your
metal detector makes it
easier to identify subtle
changes in the threshold
levels for better
detection results, and
also reduces drain on
the batteries. The Titan
2000 XD Metal Detector
has a stereo headphone
jack located at the rear
of the case.
This device is to be used
with interconnecting
cables/headphone cables
shorter than three meters.
11