Tanita BC-41 - Manual (Page 20)

Intra-day changes are thought to occur in unique cycles
arising from differences in the rhythm of individual daily
routines, occupations, and day-to-day activities.
Consequently, to obtain consistent measurement figures it is
recommended that measurements be taken under the
following conditions:
1) Measuring three hours or more after waking up, with
normal day-to-day activities carried on during this time
(simply sitting or traveling by car will keep impedance
high)
2 Measuring three hours or more after last eating
(impedance tends to fall for 2 to 3 hours after a meal)
3) Measuring twelve or more hours after vigorous exercise
(changes in impedance vary, depending on the type and
intensity of the exercise done)
4) Urinating before the measurement
5) Measuring as far as possible at the same time every day
in the case of repeated measurements (more dependable
measurements can be obtained if body weight and
impedance are both measured at fixed times)
Complying with the conditions above should result in very
consistent measurements.
When developing this device, the following six conditions
were established in deriving the regression formula:
1) No alcohol less than 12 hours prior to measurement
2) No vigorous exercise less than 12 hours prior to measurement
3) No excess food and drink on the day before measurement
4) No food and drink less than 3 hours prior to measurement
5) Urination immediately before measurement
6) No measurements during menstrual period (women)
Intra-day fluctuations (Impedance value)
Time
Between hand and foot Between both hands Between both legs
Ω
Rising
After
breakfast
Before breakfast
After lunch
Before lunch Before supper
After
supper
Before bathing
After bathing
Sleeping
Intra-day fluctuations( %FAT)
Time
Between hand and foot Between both hands Between both legs
Rising
After
breakfast
Before breakfast
After
lunch
Before lunch
Before
supper
After supper Before bathing
After bathing
Sleeping
Intra-day fluctuations (Weight)
Time
kg
Rising
After breakfast
Before breakfast
After lunch
Before lunch Before supper
After supper Before bathing
After bathing
Sleeping
BIA measures impedance and calculates body composition on the basis of this impedance. It is known,
however, that impedance can vary due to changes in the quantity and distribution of body water, which
accounts for approximately 60% of body weight, as well as changes in body temperature. Therefore, when
measurements are being taken for research purposes or on a daily basis, uniform measurement conditions
must be ensured.
Consideration should be given to two types of changes in impedance: inter-day changes and intra-day
fluctuation (cyclic changes within a single day). In the 8-electrode method, full body measurements use the
impedance between the arms and legs, while measurements for specific body parts use the impedance of
those particular body parts.
The reasons for changes in impedance are different for the upper limbs and the lower limbs. Given that the
impedance of the trunk is extremely low (a mere 5-10% of the impedance between hands and feet), changes
involving the trunk can be almost wholly ignored when measuring the impedance between hands and feet,
and the changes for the upper and lower limbs are synthesized.
When studying intra-day and inter-day changes with the 8-electrode method, it is thus necessary to
determine the respective changes for the upper and lower limbs.
1) Intra-day fluctuations (cyclic activity within a single day)
Peripheral impedance ordinarily rises during sleep and falls during activity. This is believed to occur
because extracellular fluid, typified by the blood, moves to the trunk during sleep, reducing the
extracellular fluid in peripheral areas and thus increasing impedance, and because the extracellular fluid
returns to peripheral areas during activity, causing a drop in impedance.
Intra-day activities during this cycle cause changes in body water volume and distribution due to the
consumption of food and drink as well as exercise.
The charts on page 33 illustrate one example of intra-day activities. The changes in weight, impedance, and
body fat percentage are shown on the respective vertical axes, while the measurement times are shown on
the horizontal axes (plotted points indicate the variation from the average change).
Increases in body weight occurred following the consumption of food or drink, and a sharp decrease was
seen between 20:00 and 22:00 because of a bath.
The impedance between the hands and feet, as mentioned earlier, synthesizes the changes in impedance of
the upper limbs and the lower limbs.
During the two or three hours of digestion and absorption that followed breakfast and lunch, a decrease occurred
in the impedance of both the upper and lower limbs, but the degree of change was larger in the lower limbs than
in the upper limbs. This is because the impedance of the upper limbs temporarily increased due to the impact of
specific dynamic action (SDA) from the meals but then turned downward as the body fluid mass increased. No
such increase or decrease in impedance due to SDA was seen, though, in the lower limbs. After supper, the lower
level of activity caused an increase due to lessened extracellular fluid in peripheral areas at the same time that
upper and lower limb impedance fell due to digestion and absorption; as a result no clear trend could be seen.
Among the particularly large changes that occurred were decreases in impedance while taking baths and
subsequent increases, increases and decreases attributable to exercise, and decreases after tasks such as
carrying heavy objects that require use of the upper limbs. In the course of a single day, the largest intra-day
change in the lower limbs was the decrease in impedance due to the flow of blood to the lower limbs (blood
congestion). No clear trend was noted in impedance in the upper limbs over the course of a single day, but
extremely large changes did occur as a result of certain activities in the daily routine.
a Causes of errors in impedance measurements