Technics sx-PR604/M - Manual (Page 40)

2. Use the ▲ and ▼ buttons to select an effect
group.
• The EFFECT MEMORY is for edited effects (see below).
3. Use the buttons to the right of the display to
select the type.
• If the types comprise more than one display “page,” use
the PAGE buttons to switch pages.
• If you press the VARI button to turn it ON, the effect
variation is selected.
• This display can also be accessed from the REVERB &
EFFECT MENU display. (Refer to page 109.)
EFFECT EDIT
The effects can be edited and then stored in a memory.
1. Select an effect type to use as a base.
2. Press the EFFECT EDIT button.
• The display changes to the following.
3. Use the PARAMETER ▲ and ▼ buttons to
select the parameter.
• The parameters vary depending on the effect type
selected as the base.
• (V) indicates a parameter for the VARIATION.
4. Use the VALUE
∧
and
∨
buttons to adjust the
setting.
5. Press the EFFECT NAMING button and assign
a name to the effect, if necessary.
• Refer to page 55 for details about the NAMING procedure.
6. Use the EFFECT MEMORY LIST ▲ and ▼
buttons to specify the location in which to store
the edited effect.
7. Press the WRITE button.
DIGITAL EFFECT
DIGITAL EFFECT gives the sound richness and enhances
your performance. This effect can be set for each part.
1. Select the sound to which the effect will be
applied.
2. Press the DIGITAL EFFECT button to turn it
on.
• The on or off status of the DIGITAL EFFECT is preset
for each sound.
• This effect may not work for some sounds.
• If a DRAWBAR sound is not selected for a performance
part, and if the MULTI EFFECT is off for all parts, the
nuance of this effect in the RIGHT 1 part and other parts
will differ.
CHORUS
Add breadth to the sound. This effect can be set for each
part.
1. Select the sound to which the effect will be
applied.
2. Press the CHORUS button to turn it on.
• The on or off status of the CHORUS is preset for each
sound.
Type and parameter settings
1. Press and hold the CHORUS button for a few
seconds.
• The display looks similar to the following.
2. Use the ▲ and ▼ buttons to select an effect
group.
• The EFFECT MEMORY is for edited effects (see below).
3. Use the buttons to the right of the display to
select the type.
• If the types comprise more than one display “page,” use
the PAGE buttons to switch pages.
• This display can also be accessed from the REVERB &
EFFECT display. (Refer to page 109.)
EFFECT EDIT
Your edited effect can be stored in a memory for later recall.
• The procedure is the same as for MULTI EFFECT.
DIGITAL EFFECT
CHORUS
S
o
un
ds
a
n
d
e
ff
e
c
ts
Part I Sounds and effects
40
QQTG0665