TANDBERG 550MXP User Manual
Page 20

D1372102_T550_MXP_User_Manual
10
3. ISDN cables
Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service
provider. The main number will be the number associated with the socket to which
ISDN cable number 1 is connected.
Note! Some systems and software versions do not support four ISDN lines.
North America: The system does not have a built-in network terminator. If the wall socket
provides an ISDN U-interface, an NT1 between the system and the ISDN line is needed, see
Appendix 10
.
Note! Write down the numbers associated with each of the ISDN lines. They are needed for
configuring the system.
Note! Connecting to the switched 56 network: When connecting to the switched 56 network
one of the BRI interfaces on the system may be used. Please refer to
Appendix 9
for further
information.
4. Power cable
Connect the power cable from the system
’
s power connector to an electrical distribution
socket.
5a. LAN cable
To use the system on LAN, connect a LAN cable from the
‘
Ethernet
’
connector on the
system to the LAN.
5b. Wireless LAN - Insert PC Card
Remove the
“
dummy
”
card by pressing the
‘
Eject
’
button next to the slot.
Insert the Wireless LAN PC Card.