Toshiba TDP-P6 - Manual (Page 38)

38
Red LED Behavior and Projector Errors
If the projector is not functioning properly and the red LED is blinking, con-
sult Table 2 to determine a possible cause. There are two second pauses
between the blinking cycles.
Projected image size
Table 2:
Red LED Behavior Explanation
One (1) blink The lamp won't strike after five (5)
attempts. Check the lamp and lamp door
installations for loose connections.
Two (2) blinks The lamp counter hours have exceeded
lamp life hours. Replace the lamp and
reset the lamp hours counter.
Three (3) blinks The projector has shut down the lamp.
Turn off the projector and wait one
minute, then turn the projector on again.
Replace the lamp. Contact your local
Toshiba dealer for repair if replacing the
lamp does not solve the problem.
Four (4) blinks The fan has failed. Contact your local
Toshiba dealer for repair.
Five (5) blinks The projector is overheating. Check for a
blocked air vent. Contact your local
Toshiba dealer for repair if clearing the air
vents does not solve the problem.
Solid red Unidentifiable error: contact your local
Toshiba dealer.
Table 3:
Range of distance to the screen for a given screen size
Diagonal
Screen Size
(inches/m)
Distance to screen
Image Width
(inches/m)
Maximum
distance
(feet/m) Minimum
Distance
(feet/m)
40/1 32/0.8 5.6/1.7 4.8/1.5
50/1.3 40/1 6.9/2.1 6/1.8
60/1.5 48/1.2 8.2/2.5 7.2/2.2
100/2.5 80/2 13.8/4.2 12.1/3.7