Technicolor - Thomson 210i - Manual (Page 17)

SpeedTouch 210i
13
Your particular system may differ from the window shown here. Check if you have an
Ethernet Network Interface card (NIC) installed. If not, refer to the installation
documentation from the NIC card manufacturer and install the card and drivers.
If you have installed the NIC card,
1. Click the Add button. The Select Network Component
Type dialog box will open. This box has four options: Client, Adapter, Protocol,
and Service.
2. Select Protocol and click the Add button. The Select Network Protocol dialog
box will open.
3. Select Microsoft in the left scrolling window, then select TCP/IP on the right, and
click OK. It will return to the Network dialog box.
Configuring the TCP/IP Protocol
1. On the Network dialog box Configuration card, select TCP/IP and then click
Properties. The TCP/IP Properties dialog box will open.