Removing/replacing the touchpad assembly, 21 removing/replacing the touchpad assembly – Texas Instruments 60X User Manual
Page 114
6-30 Field Service
4.
Replacement is the reverse of Steps 1 through 3.
Figure 6-26 Removing/Replacing the PCMCIA Module
6.5.21 Removing/Replacing the Touchpad Assembly
Use the following procedure to remove/replace the Touchpad Assembly:
1.
Remove the Keyboard Assembly as described in Paragraph 6.5.4.
2.
Remove the Top Cover Assembly as described in Paragraph 6.5.11.
3.
Refer to Figure 6-28; remove the center screw and disconnect the Touchpad
cable J1.
4.
Remove the Touchpad main sensor and connector unit.
5.
Remove the two side screws and remove the metal plate.