Installation, Positioning and connection – Ariston MBZE 45 NF User Manual

Page 16

! Before operating your new appliance please read these

instructions carefully. They contain important information

for safe use, installation and care of the appliance.

! Please keep these operating instructions for future

reference. Pass them on to possible new owners of the

appliance.

Positioning and connection

Positioning

1. Place the appliance in a well-ventilated, dry room.

2. Do not obstruct the rear fan grills. The compressor and

condenser give off heat and require good ventilation in order

to operate correctly and save energy.

3. Leave a space of at least 10 cm between the top part

of the appliance and any furniture above it, and at least 5

cm between the sides and any furniture/side walls.

4. Ensure the appliance is kept well away from any

sources of heat (direct sunlight, electric stove, etc.).

Levelling

1. Install the appliance on a level and sturdy floor.

2. If the floor is not perfectly horizontal, adjust the

refrigerator by tightening or loosening the front feet.

Electrical connections

After transportation of the appliance, carefully place it in

an upright position and wait at least 3 hours before

connecting it to the electricity mains. Before inserting the

plug into the electrical socket ensure the following:

The appliance is earthed and the plug is compliant

with the law.

The socket can withstand the maximum power of the

appliance (this is indicated on the data plate in the

bottom left section of the refrigerator compartment),

for example 150 W).

The voltage is in the range of values indicated on the

data plate located on the bottom left section (e.g. 220-

240V).

The socket is compatible with the plug of the

appliance.

If the socket is incompatible with the plug, ask an

authorised technician to replace it (see Assistance). Do

not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced by

authorised technicians only (see Assistance).

! The manufacturer declines any liability should

these safety measures not be observed.

Bar compartment

The stiffness of the door

opening/closing movement for

the bar compartment may be

adjusted. When you are in front

of the appliance, turn the two

lateral rods to the left if you wish

to stiffen the movement, or to

the right if you wish to loosen the

movement.

! The two brackets must be adjusted to the same

stiffness level. Turn each rod the same number of times,

in the same direction.

Installation