TANDBERG Utility - Manual (Page 41)

3 General Use
33
3.12.1 Add New Contact
The Add New Contact function is available from
My Contacts .
It is recommended to add new contacts remotely using the IP address and the web-interface or
telnet.
To perform the following using the remote control the Kiosk Mode must first be deactivated. This
is done via the telnet or web-interface, or by pressing 5 times on the Phone Book symbol then
once on the number 3 on the remote control. The remote control can be directed to the inside
lower edge of the Compass MXP cabinet (i.e. the unit must be temporarily removed from the
wallplate). On the Utility MXP the remote control can be held directly in front of the small hole just
under the speaker grill.
Add a new contact to My Contacts by:
1. Select the New Contacts button to open the New Contacts dialog box.
2. Enter Name by using the letter keys on the remote control. Input will automatically be
interpreted as letters. Toggle between capital letters and small letters by pressing the #
button on the remote control. The maximum name length is 30 characters. For numbers,
press the # button for one second.
3. Enter Number by using the number keys on the remote control. Input will automatically be
interpreted as numbers. The maximum number length is 60 numbers. Use a star as
separator in IP addresses. For letters, press the # button for one second.
4. Alter the default setting of Call Type if necessary.
5. Alter the default setting of Network if necessary.
6. Alter the default setting of Bandwidth if necessary. For bandwidth 2x64 kbps or 2x56
kbps, two numbers are required, see Default Call Settings for more details.
7. Alter the default setting of Restrict (56k) if necessary.
8. Press OK to save.
Figure 3-11. Add New Contact