TANDBERG Utility - Manual (Page 37)

3 General Use
29
3.10 Using the Handset
The handset has different functions depending on the setup of the unit, and depending on if the
unit is outside or inside a call.

When outside a call and with autodial activated, lifting the handset will waken the system
from standby mode and will start to dial through the names stored in My Contacts.
Replacing the handset onto the cradle will end the call.

When outside a call and with autodial deactivated, lifting the handset will waken the
system and show the Kiosk Menu if activated, otherwise self view will be shown.
Replacing the handset onto the cradle will have no consequence.

When an incoming call is ringing on the system and with auto-answer deactivated, lifting
the handset will accept the call. Replacing the handset onto the cradle will end the call.

When incoming call is ringing on the system and with auto-answer activated, lifting the
handset after the call has been auto-answered will switch between built-in speaker &
microphone and the handset. Replacing the handset onto the cradle after an auto-
answered call will not end the call, but will switch back to the built-in speaker and
microphone.

When inside an existing call lifting the handset switches between the built-in loudspeaker
and microphone and those contained in the handset. This feature is the same for both the
Utility MXP and the Compass MXP. The switching is a toggling action, therefore upon
replacing the handset on the cradle the unit will switch back to the built-in speaker and
microphone.
The above description of handset functions can also be related to the actual units and their
default settings for Auto Answer and Auto Dial.
Utility MXP
(Default settings: Auto answer is ON and Auto dial is ON.)
Lifting the handset outside a call will wake up the system and start to dial the numbers listed in
the phone book. Thereafter, replacing the handset will end the call.
An incoming call will automatically connect the call with speaker active. Lifting the handset in a
call will switch from speaker mode to handset mode. If you hang up in a call, it will switch to
speaker mode again.
Compass MXP
(Default settings: Auto answer is OFF and Auto dial is ON)
Lifting the handset outside a call will wake up the system and start to dial the numbers listed in
the phone book. Thereafter, replacing the handset will end the call.
An incoming call will be connected by lifting the handset. Thereafter, replacing the handset on the
cradle will end the call. Note: If an incoming call is answered by pressing the central button,