TANDBERG Utility - Manual (Page 23)

3 General Use
15
3 General Use
Wake up the system
When the system is not in use, it is in standby mode and the screen is black. Wake up the system
by picking up the handset. An incoming call or pressing any key on the Compass MXP will also
wake up the system.
Quick Key for IP Address
If the IP address of the system has been mislaid or forgotten it can be shown temporarily on the
screen by pressing the central button on the Compass MXP for at least 5 seconds, until the
address appears on the screen. On the Utility MXP the remote control can be removed from the
cabinet and the OK button pressed in the same manner.
Quick Key to Deactivate Kiosk Mode
If it is required to deactivate the Kiosk Mode without using the telnet or web interface the following
must be performed using the remote control stored inside the cabinet. This is only possible if the
setting Allow Use of Remote Control has been saved as ON. Please refer to later chapters on
where the remote control should be directed to enable IR reception.

Press 5 times on the Phone Book symbol then once on the number 3.