Tascam CC-222MKII - Manual (Page 30)

5 – Recording CDs—Advanced recording
30
TASCAM CC-222MKII Owner’s Manual
Sync recording (start)
The conditions under which an input signal is used as
the trigger to start recording in the
SYNC ALL and
SYNC 1 modes are:
• when recording digitally from a DAT deck, a digi-
tal track start signal is detected (the signal level is
ignored):
• when recording digitally from a CD or MD deck, a
digital track start signal is received, and the signal
level subsequently rises above the trigger level:
• when recording from any source other than the
ones described above (that is, any digital source
other than DAT, CD or MD, or any analog source),
recording starts when the input signal level exceeds
the trigger level.
In this last case, if the signal level is already higher
than the trigger level, recording starts immediately.
Sync recording (stop)
SYNC ALL In the SYNC ALL mode, recording
stops when the input level drops below the trigger
level for more than six seconds.
Also note that in this mode, the auto track function is
enabled (see “Automatic track division” on page 31).
SYNC OFF Automatic synchronized record start
and stop functions are disabled and must be per-
formed manually.
SYNC 1 In the SYNC 1 mode, recording stops at
the start of the next track (when the level of the first
track has gone below the trigger level for less than
six seconds and the level of the second track goes
above the trigger level)
or
When the input level goes below the trigger level for
more than six seconds (as in the
SYNC ALL
mode).
level
time
S_LVL
Track start signal
received Start of recording
level
time
S_LVL
Track start signal
received
Start of recording
level
time
S_LVL
Trigger level
exceeded
Start of recording
level
time
S_LVL
STOP
6 seconds level
time
S_LVL
Less than
six seconds
Recording
stops