Toshiba W-727 - Manual (Page 38)

38
DSS ® Satellite Receiver Set-up (continued)
VCR display
OFF: if your DSS ® satellite receiver is
NON remote-controllable.
• Satellite channels will be selected by
the own channel selector of the DSS ®
satellite receiver.
The VCR channel should be set to the
output channel of the DSS
® satellite
receiver.
→
Go to step 8.
7
Select “BRAND TYPE” using STOP, and enter a brand code
of your DSS ® satellite receiver using number buttons. Refer
to the table on the next page.
Example: For a TOSHIBA DSS ® satellite receiver, identified by
number 99.
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
®
satellite receiver on the VCR so that it can receive the infrared signal.
8 Press PROG. twice to exit.
Notes
• If your satellite channel does not change to 200 in step
7 , the DSS ® satetllite
receiver will not be able to change channels in the timer recording. In this
case, set “CONTROL” to “OFF” in step
6 .
• The VCR Plus+ C system recording is not available on satellite channels.
• The DSS
® satellite receiver control is not compatible with the cable box
control.
TOSHIBA 99
RCA 98
SONY 97
PANASONIC 96
Buttons to control a remote-
controllable DSS
® satellite receiver
Once you complete the set-up for a remote
controllable DSS
® satellite receiver, your DSS ®
satellite receiver can be controlled by the
following buttons on the remote control of the
VCR.
•
POWER (CABLE BOX)
To turn the DSS
® satellite receiver on or off.
• CH (CABLE BOX)
To select satellite channels in the upper or
lower direction. (not applicable to some brands
of DSS
® satellite receiver.)
• Number buttons (0 – 9)
To select desired channels to record.
Table of DSS ® satellite receiver brand
codes
Brand name of your
DSS
® satellite receiver
Brand code
3 ®
W-727/Eng (24-39) 2/28/02, 4:00 PM 38