Toshiba W-727 - Manual (Page 33)

33
RECORDING
Preparation
• Select the video channel (3 or 4) or video input mode on the TV.
• Set “TV/CATV” on the CH MEMORY screen to “CATV” (page 16).
(Example)
(Continued)
Cable Box Set-up
1 Press PROG. to display the MENU screen.
2
Select “PRESET” using FF or REW, and press ENTER.
3 Select “CABLE BOX/DSS” using PLAY/x2 or STOP, and
press ENTER.
4
Select “NO” or “C.BOX” using FF or REW according to your
connection type.
NO: • Type A
• Type C (A/B switch “A”)
• Cable channels will be selected using
CH/TRK on the remote control or
CHANNEL on the VCR.
→
Go to step 8 .
C.BOX: • Type B
• Type C (A/B switch “B”)
• Type D
→
Go to step 5 .
5 Select “OUTPUT CH” using PLAY/x2 or STOP, and enter
either of the following according to your connection.
Type B, C: the output channel number of
your cable box using
number buttons.
(Usually 3 or 4. Check the rear of the
cable box.)
Type D: the line input mode “L1” using
I.SELECT.
6 Select “CONTROL” using PLAY/x2 or STOP, and set to “ON”
or “OFF” using FF or REW.
ON: if your cable box is remote-
controllable.
• Cable channels will be selected by
CH
(CABLE BOX) on the remote control.
The VCR can change the cable
channel to the desired one when timer
recording or VCR Plus+ C system
recording starts.
→
Go to step 7 .
OFF: if your cable box is NON remote-
controllable.
• Cable channels will be selected by the
own channel selector of the cable box.
The VCR channel should be set to the
output channel of the cable box.
→
Go to step 8 .
3 ®
USE no C. Box DSS
TV VCR
PROG. ENTER
TV/ VCR
POWER
CH/TRK
TV VOL
I.SELECT
REMAIN/
COUNTER DISPLAY COUNT RESET
SP/ SLP REC TIMER
SLOW PLAY/x2 PAUSE/STILL
REW F F
CANCEL
A.SELECT
EJECT
0
VCR Plus+ CH
CABLE BOX
CM SKIP POWER
1 2 3
4 5 6
7 8 9
Number
buttons
100
I.SELECT
REW
FF
PLAY/x2
STOP
ENTER
PROG.
100
STOP
CURSOR
USE no C. Box DSS
OUTPUT CH 2 CH
CO
n TROL Off on
USE no C. Box DSS
OUTPUT CH 3 CH
BRA n D TYPE no. 1
CO n TROL Off on
W-727/Eng (24-39) 2/28/02, 4:00 PM 33