Toshiba W-727 - Manual (Page 16)

16
Incoming Antenna/Cable(CATV) Signals
The VCR scans through all receivable TV and CATV channels and stores only the active
ones in your area into the memory. Once the storing is finished, you can select a desired
channel using
CH/TRK.
Preparation
• Turn on the TV, and select the video channel (3 or 4), or the video input mode if you made the Audio/Video
connection (page 11).
• Press I.SELECT so that the channel number will appear if “L1” or “L2” is displayed in the VCR display.
Incoming Antenna/Cable(CATV) Signals
1 Press PROG. to display the MENU screen.
2 Select “PRESET” using FF or REW,
and press ENTER.
3
Select “CH MEMORY” using
PLAY/x2 or STOP, and press
ENTER.
4 Set “TV/CATV“ to “TV” or “CATV” using FF or REW.
TV: To store channels received via the antenna.
CATV: To store channels received via the incoming cable.
5 Select “AUTO SCAN” using
PLAY/x2 or STOP, and press FF to
set to “ON”.
The VCR starts scanning and the
channels are stored in the VCR in
ascending order. When the scanning is
finished, the screen automatically
returns.
6
Press PROG. twice to exit.
PREPARATION
Storing Channels on the VCR
This section is required if you receive only normal TV or unscrambled cable channels, or use a cable box
between your TV and the VCR.
AUTO SCA n 2 CH on
TV VCR
PROG. ENTER
TV/ VCR
POWER
CH/TRK
TV VOL
I.SELECT
REMAIN/ COUNTER DISPLAY COUNT RESET
SP/ SLP REC TIMER
SLOW PLAY/x2 PAUSE/STILL
REW F F
CANCEL
A.SELECT
EJECT
VCR Plus+ CH CABLE BOX
CM SKIP POWER
1 2 3
4 5 6
7 8 9
0
Number
buttons
100
CURSOR
STOP
1,6
ENTER
PLAY/x2,
STOP
REW
I.SELECT
100
FF
W-727/Eng (10-18) 2/28/02, 3:56 PM 16