2 the cc2533 remote control, Cc2533 r, Emote – Texas Instruments CC2533 User Manual
Page 7: Ontrol
swru266
7/25
USB dongle
The USB dongle can be programmed to
replace the functions of the Target Module. It
supports virtual serial port interface and HID
(Human Interface Device) USB profiles. It
can also be programmed to be used as
packet sniffer of RF activity.
In addition the kit includes the following accessories:
2 AA batteries
2 Mini-USB cables, one for the target module and one for the CC Debugger
1 USB extension cable for the USB dongle
1 10-pin flat cable with 2x5 2.54mm connector
1 10-pin flat cable with 2x5 1.27mm connector
1 Converter board 2.54mm-1.27mm connector
The CC2533 RF4CE Basic development kit includes the following software:
Application
Description
Download link and reference
RemoTI stack
library and sample
applications
The embedded software included
with the remote control and target
board. Allows the development kit to
be used out-of-the-box as an RF
remote control.
SWRC131
RemoTI emulator
PC tool
A PC tool that can be connected to
the USB interface of the target
module to test
Included in the RemoTI SW
package
SmartRF Packet
Sniffer
A PC tools that can be used to
display all RF4CE packets on the
network. Requires a packet sniffer
hardware adapter to be used with
RF4CE.
www.ti.com/lit/zip/swrc045
SmartRF Flash
Programmer
Programming tool for programming
hex files.
http://focus.ti.com/docs/toolsw/fold
ers/print/flash-programmer.html
IAR EW8051 C-
compiler
www.iar.com/ew8051
Additional CC Debugger and packet sniffer hardware adapters can be purchased from the TI
eStore on
4.2 The CC2533 Remote Control
The remote control is powered by 2xAA batteries included with the development kit.
Figure 1 shows the key layout of the remote control with some of the important keys.
-
Pairing key, pair the remote control with the target
-
Packet error rate key, used to start the packet error rate mode. Use this mode to test
range and RF quality. See the RemoTI Sample Application Users Guide (SWRU201)