5 programming and debugging, 1 using the smartrf flash programmer pc software, 2 programming and debugging the remote control – Texas Instruments CC2533 User Manual
Page 14: Programming and debugging, Sing the, Mart, Rf f, Lash, Rogrammer, Software
swru266
14/25
5 Programming and Debugging
5.1 Using the SmartRF Flash Programmer PC software
The SmartRF Flash programmer PC software is used for programming the software on the
remote control and the target module. The RemoTI installation package includes two hex files
in the
Remote control:
rsa_CC2533.hex
Remote Sample Application
Target module:
rnp_CC2533.hex
Remote Network Processor
Figure 8: SmartRF flash programmer interface
5.2 Programming and debugging the remote control
The CC2533 can be programmed and used as an in-circuit emulator using the debugging
interface on the rear under the battery compartment cover. The CC Debugger is used to
program and debug remote control applications.