Texas Instruments CC2533 - Manual (Page 8)

swru266
8/25
for instructions to run the PER and latency test, and the RemoTI Latency and Packet
Error Rate Application Note (SWRA262) for sample measurements.
- On/Off, switches power on the target. Note that most applications can still receive
remote control commands when powered off, but the latency is longer
Figure 1: Remote Control Key layout
4.3 The Target Module
The target module includes the following features and interfaces:
-
Virtual serial port USB interface to allow using a COM port on a PC
- I2C/SPI/UART interface for connection to A/V equipment
- Flash memory for storage of Over the air (OAD) images and IR codes
- 1 channel IR drivers and LED for IR repeater function
- IR sensor input
o Learning IR code functionality
o Direct translation of IR codes to RF commands
- Buttons for reset and pairing
- Status LEDs
The target module is powered from the USB interface connected to a PC or a power adapter
with USB interface.
Pairing key
Packet Error Rate
On/Off